There are about 20 drops of water in 1 ml, so a 5 ml bottle holds about 100 drops, 10 ml about 200, 15 ml about 300 and 30 ml about 600. Essential oils give smaller drops, about 30 to the millilitre on average, which makes a 5 ml bottle of oil roughly 150 drops.

Both numbers are averages, not constants. A drop is whatever falls from the tip when its weight beats the liquid's grip on it, so its size depends on the liquid and on the dropper. This guide gives the counts for the common bottle sizes, explains where the 20 and the 30 come from, and shows how to count your own.

Drops per bottle size

VolumeWater-like liquids (about 20 drops per ml)Essential oils (about 30 drops per ml)Essential oils, range seen in tests (20 to 40 per ml)
1 ml203020 to 40
5 ml100150100 to 200
10 ml200300200 to 400
15 ml300450300 to 600
30 ml (1 oz)600900600 to 1,200

A bottle sold as 1 oz holds one US fluid ounce, 29.57 ml, and is usually labelled 30 ml. At 20 drops to the millilitre that is just under 600 drops. In practice you get a few less from any dropper bottle, because the pipette cannot draw up the last of the liquid.

Where "20 drops per ml" comes from

The figure goes back to the pharmacist's medicine dropper. The United States Pharmacopeia describes it in general chapter <1101>: a glass tube with a rubber bulb, its tip a round opening about 3 mm across. Held upright, it delivers water in drops that each weigh between 45 and 55 mg. A millilitre of water weighs almost exactly a gram, so that is 18 to 22 drops per millilitre, or 20 in round numbers, and one drop is about 0.05 ml.

The same chapter adds two warnings. Most liquids differ from water in surface tension and viscosity, so they do not give the same drop. And where the dose matters, the dropper should be calibrated for the liquid it will be used with; even then, a volume error of up to 15% is accepted in normal use.

Why essential oils give more drops

Surface tension is what holds a drop on the tip. Water's is high, so a water drop grows large before it falls. Essential oils and alcohol-based tinctures hold on less strongly, so their drops let go sooner and are smaller, and the count per millilitre goes up.

The best published numbers for essential oils come from the Tisserand Institute, which summarised three sets of measurements made in 1999, 2000 and 2016. Between them they covered 49 essential oils, several brands and three to seven styles of dispenser. All three found the same average: 20 drops weighed 0.66 g. That works out to about 30 drops per millilitre, the figure the Institute uses in its dilution chart. Individual oil and dispenser combinations ranged from about 20 to 40 drops per millilitre.

So if a recipe says "10 drops in 10 ml of carrier oil", it is asking for about a third of a millilitre of essential oil with a typical bottle, and anywhere from a quarter to half a millilitre with an unusual one.

What changes the size of a drop

  • The tip. A wider opening holds a bigger drop. That is why the same oil gives a different count from a glass pipette than from the plastic orifice reducer pressed into the neck of a 10 ml essential oil bottle. Our dropper bottle guide sets out how orifice size and drop rate are matched.
  • The liquid. Surface tension sets the drop size, and viscosity sets how fast drops come. A thick serum can drip so slowly that people squeeze the bulb harder, which changes the drop again.
  • How it is held. The pharmacopoeia figure is for a dropper held vertically. Tilted, the drop runs along the side of the tip and leaves at a different size.
  • Temperature. A cold oil is thicker and flows more slowly than the same oil at room temperature.

The size of the bottle is not on the list. Put the same dropper on a 15 ml and a 30 ml bottle and each drop is the same; the larger bottle simply holds more of them. How pipette length and neck finish change from one capacity to the next is covered in the dropper bottle size chart.

How to count the drops in your own bottle

  1. By volume. Count drops into a 1 ml oral syringe or a graduated measuring cylinder until the liquid reaches the 1 ml mark.
  2. By weight. Put a small dish on a scale that reads to 0.01 g, zero it, and count 20 drops into the dish. For water, 20 drops should weigh close to 1 g. For other liquids, divide the weight by the liquid's density to get millilitres, or simply use the weight of 20 drops as your own reference.

Do it two or three times and take the average.

For brands: write the dose in millilitres, check it in drops

If a label tells customers to use a number of drops, that number only means something for the dropper that ships with the product. The pharmacopoeia's advice applies to cosmetics and supplements too: measure the drop with the actual formula and the actual dropper, and repeat the check whenever either changes. A new bulb material, a different pipette tip or a reformulated serum can all move the count.

Bottle formats for drop-dosed products are covered on our pages about 1 oz dropper bottles, 10 ml essential oil bottles and serum bottle sizes. If you are specifying a dropper bottle and closure for a new product, send the capacity, the formula type and the target dose through the quote form.

FAQ

How many drops are in 1 ml?

About 20 for water and water-based liquids, and about 30 for essential oils, with a range of roughly 20 to 40 depending on the oil and the dropper.

How many drops are in 5 ml?

About 100 drops of a water-based liquid, or about 150 drops of essential oil.

How many drops are in 10 ml?

About 200 drops of a water-based liquid, or about 300 drops of essential oil.

How many drops are in 15 ml?

About 300 drops of a water-based liquid, or about 450 drops of essential oil.

How many drops are in 30 ml, or 1 oz?

About 600 drops of a water-based liquid, or about 900 drops of essential oil.

How many ml is one drop?

About 0.05 ml for water from a standard dropper. An average essential oil drop is about 0.03 ml.

Sources